As a Bowling Green commercial roof repair contractor, we trace leaks and fix the failed seam, flashing, fastener, or drain on flat, metal, and industrial roofs.
Bowling Green commercial roof repair works best when most of the roof is still firm and dry, and the trouble sits in a few spots you can point to.
Wondering whether to repair or replace a flat roof in Bowling Green, KY? We still stop the active leak first, then show you what restoration or replacement would involve.
Four steps, in this order, on every repair call.
Starting at the stain inside, we walk the roof above and upslope of it, probe seams, test fasteners, and check flashing, drains, and penetrations around each suspect spot.
Each finding gets a mark on a roof plan, a dated photo, and a label: permanent repair, temporary fix, or a sign that the area needs restoration.
Patches, flashing, and fasteners go on with materials that match the roof system, after the surface is cleaned, dried, and primed to the maker's instructions.
Before we leave, every opened seam or flashing is closed, the area is swept for loose screws, and you get the photos plus a list of what was fixed.
Four kinds of repair work, each matched to the roof system on your building.
For TPO, EPDM, PVC, modified bitumen, and built-up roofs on warehouses, offices, and strip centers. Water on these roofs finds open laps, punctures, blisters, and base flashing pulled off the parapet.
Typical Repairs
Exposed-fastener and standing-seam buildings leak where the panels move: screw rows, end laps, ridge caps, and gutters. Daily expansion loosens fasteners and dries out washers until rain runs down the shank.
Typical Repairs
A ceiling stain rarely sits right under its source. Water runs along deck flutes and purlins first, so we trace it with visual checks, moisture readings, infrared scans, and controlled water tests.
Typical Repairs
Plants and large warehouses need repairs that fit around production. Work runs in small areas, with planned shutdowns for exhaust fans and units, marked walkways, and every opened detail closed before the crew leaves.
Typical RepairsTell us where it drips and when it rained.
Seen a stain, a loose panel, or storm damage? Send the address for a free estimate.
Get A Free EstimateWhat changes on a Bowling Green roof once the failed details are fixed.
Roof leak repair for warehouses in Bowling Green starts here: match what you see inside to the roof detail that usually causes it.
Water entering at a curb, pipe boot, or seam upslope, then running along the deck flutes before it drops.
We trace upslope from the stain, mark each suspect detail, and water-test sections one at a time.
A clogged strainer, a drain set too high, or a sagging section of deck under the membrane.
Drains get cleared and reset, and a persistent pond gets a deck check before any slope work.
Seam edges lifting as TPO or EPDM ages and the lap bond lets go in the sun.
Lifted laps are cleaned and rewelded on TPO, or primed and covered with seam tape on EPDM.
Backed-out screws, cracked washers, or an open end lap on the panels overhead.
Fastener rows get tightened or upsized with new washers, and leaking laps get new butyl tape.
Wind pulling at the perimeter where coping, gutters, and edge flashing are fastened.
Bent metal is refastened or replaced, and lifted membrane at the corners is adhered again.
We take commercial roof repair work in Bowling Green and eight towns nearby. Outside them? Call us or send us a message.
Storefronts and multi-tenant shops in Simpson County, where curb and fan repairs get planned around store hours.
Franklin commercial roof repair
Warehouse and distribution roofs in Logan County that wear thin along the walk path from the hatch.
Russellville commercial roof repairAllen County shops that need a winter patch now and a permanent repair once the roof dries out.
Scottsville commercial roof repairButler County metal buildings where cracked skylight panels and rusted sheets call for matched replacements.
Morgantown commercial roof repairLogan County shops and farm buildings, where we sort true roof leaks from cold-morning condensation.
Auburn commercial roof repairOlder Barren County buildings with parapets, coping, and ridge caps that need steady exterior upkeep.
Glasgow commercial roof repairSigns, lights, and brackets fastened through Barren County roofs, plus the screw holes they leave behind.
Cave City commercial roof repairEdmonson County buildings on low ground, where gutters and downspouts decide where roof water lands.
Brownsville commercial roof repairCrews fix the spots where water gets into the building and the damage that lets it in.
On warehouses, plants, churches, and shops that means split seams on TPO and EPDM, flashing pulled loose at parapets and curbs, punctures, backed-out screws and open end laps on metal, and clogged or cracked drains. Once damage spreads past a few areas, restoration or replacement comes up.
They turn small defects into leaks. The National Weather Service puts the city's 1991 to 2020 average near 50 inches of rain and melted snow a year, with January averaging about 37 degrees.
Overnight ice in a seam edge or a metal lap widens the gap a little each cycle, so late-fall drain cleaning and seam checks catch most of it early.
Look for bruised or cracked membrane, dented panels and ridge caps, and broken skylights or vent caps. A bruised spot on single-ply can look normal from the ground, so the roof walk checks soft areas over the insulation and cracked cover board under the sheet.
Dents with intact paint are mostly cosmetic; cracked membrane and split seams need repair before the next rain.
Three things set most of the price: how many problem spots there are, how hard they are to reach, and how much wet material has to come out.
Roof type, the count of seams, curbs, and penetrations involved, rusted panels or purlins, lifts, and work timed around production add to it. One open seam near the hatch costs far less than reflashing a long parapet wall.
An active leak needs at least a temporary fix right away, because the water keeps spreading through the insulation. Mastic, tape, or a tarp can slow it during cold, wet weeks.
The permanent repair, such as a welded patch or new flashing, goes on once the surface is clean and dry, and the temporary material comes off first.
Send the property address and what you are seeing inside, and we will set up a roof walk.
Leave a name and number and we will call about your roof.
Or call (364) 207-8996 now.